Tempsmart Dc Cartridges (48 Ml) - Universal Composite - GC

Tempsmart DC Dual-Cure Material

The first dual-cure, plasticiser-free temporary material that allows you to create naturally beautiful and durable temporaries in 3 minutes.

Features of Tempsmart DC:

• Convenient working time with reduced setting time.
• 1:1 mixing ratio cartridge, plasticiser-free.
• Virtually no inhibition layer, perfect for quick polishing.
• Restorations in just 3 minutes.
• Aesthetic and durable restorations.
• Non-tacky, smooth surface.
• Its long polymer chains offer high fracture resistance.
• With ultra-fine fillers a long-lasting superior gloss finish is achieved.
• Easily repairable and relineable with Tempsmart DC, Unifast III or G-ænial Universal Injectable.
• Available in 6 shades, all with natural fluorescence for beautiful results.
• Contents: the 10 ml size comes with 10 mixing tips and the 48 ml size comes with 16 mixing tips.

Instructions for use:

• Crowns.
• Small or large-span bridges.
• Temporary or permanent inlays.

Step-by-step guide:

1. Initial situation. Create a mock-up if necessary and take an impression prior to preparation.

2. Discard a pea-sized amount of material before dispensing. Place TEMPSMART DC into the impression.

3. Place the impression intraorally within 45 seconds of starting to dispense.

4. Between 2 and 2.5 minutes after starting to mix, remove the excess and remove the restoration from the mouth.

5. Remove the temporary from the impression, light-cure the occlusal surface for 5 seconds on each side (self-curing: wait 5 minutes after dispensing the material).

6. Restorations prior to finishing.

7. Finish and polish the surface. Check the bite to minimise stress and occlusal load.

8. Place the temporary restoration. Use Freegenol or Fuji Temp LT to cement it.