XP-Endo Rise Sequence for Sterile Retreatment (3 pcs) - FKG

XP-endo Rise Retreatment Sequence

Characteristics of the XP-endo Rise Retreat Sequence:

• Use the tip of the XP-endo® Rise Shaper in the prepared space of the gutta-percha, spread it slightly apart and start the motor at 1000-2500 rpm.
• Recommended1000 rpm- 1 Ncm.
• Peck until the tip of the XP-endo® engages the gutta-percha.
• Use the XP-endo® Rise Shaper to help advance the down the duct until the working length or the end of the previous filling material is reached.
• XP-endo® Rise Shaper should spiral around the gutta-percha.
• With the XP-endo® Rise Shaper you can perform 10-15 smooth and prolonged movements.
• Set the working length of the duct on the Finisher R (ISO 30).
• The Finisher R in the duct has a motor start of (800-1000 rpm, 1 Ncm).
• Use the Finisher R slowly towards the inside of the duct.
• Use the Finisher R for at least 1 minute.
• Contents: 21mm.
• Content: 1 D-Race DR1 (030/.10, 15mm) + 1 XP-endo Rise Shaper (030/.04 21mm) + 1 Finisher R (030/.00 21mm)